What it takes to build a Plumbing System

plumber


For the design of your plumbing system, technical skills are required together with attention to detail and the use of specific tools. With the hydraulic system we refer to a wide set of essential elements to know to design it in an optimal way. To get an idea, just think that cold water enters the home, in addition to escaping from the supply systems that will be installed, in order to also distribute hot water, it will need to be heated by passing through a boiler.

The sanitary is then composed of two pipes, one for hot water and one for cold water, which will end up in the drainage points, which thanks to a siphon there will be no exhalation. All the pipes of each sanitary will then convey into a single pipe that will be directed to the sewer. There are many ways to bring water to the various parts of the house. Let’s see what it takes to build a plumbing system with the help of a very competent plumber from Milan.

What you need and installation advice:


Propylene pipes are very practical for making pipes for the plumbing system. While for the junctions a tool called poly welder is needed, which will be used to weld the parts by heat. Snap shears are used to cut pipes without burrs and with as precise cuts as possible.

The technique used to join the tubes together is with heat, going to heat them with the poly welder to ensure that they soften and can be joined. After completing this step, the pipes must be inserted into each other, being careful to respect their trend by exerting pressure on them. Once a single piece has been obtained, the hydraulic seal will be guaranteed. If you are dealing with the design of complex systems, the poly welder is best if firmly fixed to the workbench, to make the right joints between bars and fittings.

Then the use of copper pipes is used, which being an excellent conductor of heat, to ensure that there is no drop in thermal efficiency, is coated on the outside with a fairly thick plastic sheath. Here are some tips water leak fix, you might be interested in

These are cut to be closed by a wheel cutter, thanks to a thin disc. If bends are required, the copper pipes are very flexible, so they are inserted into a particular steel spring that avoids crushing the pipe so as not to compromise the passage of water. An alternative, if this particular steel spring is not used, is to fill the tube, for example, with sand, to avoid crushing when making the bend.

Preparation of the joint:


After inserting the ring nut before starting, the flared mouth joint is cut and debarred the pipe. Then the tube is inserted into the clamp according to the diameter so that the final part is flush with the matrix and then tightens. Once the clamp is positioned on the matrix, the screw is tightened and the male widens the edges of the tube, and then rests the conical part of the joint on the flared opening. It will be necessary to solder the copper with a torch; then the tin or lead wire is placed at the junction point between the pipe and the fitting.

It would be ordinary to fix the copper pipes to the wall using steel pipe clamps that firmly support the pipe to the wall, fixed with a screw that on the other side will provide a sturdy connection thanks to an expansion plug. In the case of individual repairs, it is possible to use special detectors that “see” under the tiles in order to restore, at least temporarily, the functionality of the plumbing system.

By aamritri

Leave a Reply

Your email address will not be published.

Related Posts